Docking Drawer Fire Guard Power Outlet With Smoke and Heat Sensor, 120 Volt, 15 Amp - NEMA 5-15R

De-Energizes The Outlet & Appliance If Smoke Or Heat Is Detected In Your Grow Room To Stop Fires Before They Start

Protect Your Grow Room & Grow Equipment

These units are perfect for protecting your grow. You could hook up one light controller to this outlet, and control/protect HUNDREDS of lights! In the event of a problem, the sensor would notice any smoke or heat. It would then immediately kill the power to the outlet & your controller, turning off all of your lights in your grow room. This simple product could save you time & money!

The Facts: Fire and Smoke in the Home

A Consumer Reports analysis of National Fire Incident Reporting System (NFIRS) showed more than half of all house fires (approximately 69,000) throughout a seven-year span had appliances –like dishwashers, refrigerators and microwaves– listed as the primary cause.

Docking Drawer’s Fire Guard Outlet is a single gang electrical outlet featuring one NEMA 5-15 receptacle and one interlock switch connector, as well as a smoke and heat sensing unit. Mount the Smoke and Heat Sensor inside any enclosed or semi-enclosed space to de-energize the outlet (and power off any connected devices) when smoke or rapidly rising heat is detected.

Mounting Details

Use 4 screws to mount near the appliance or device that will generate smoke or heat, positioning as high up as possible or above the smoke or heat source.

Professional installation required.

Possible applications include:

• Grow Tents
• Greenhouses
• Microwaves
• Dishwashers
• Appliance Garages
• Gas Dryers

• 3D Printers
• Battery Charging Stations
• AV Closets
• General Closets
• Or any place where devices are plugged in and left unattended

Outlet Specs

Input	100 - 125 VAC, 50/60 Hz
AC Output	15A@125VAC, 1875 VA MAX
DC Output	-24VDC @ 100mA MAX
DC Power Supply	IEC Class II
Number of Receptacles	(1) NEMA 5-15R
Tamper Resistant	±5% rh (resolution: 0.1 rh)
LED Indicator	Yes
Conformance	UL60730, UL498, EN61558, EN60730, EN62386, CSA C22.2#42
Dimensions	5ft (1.5 Meters)
Environmental	-10 °C to +50 °C, non condensing
Warranty	2 Years

Sensor Specs

Type of Sensor	Smoke and heat sensor
Cable	10 ft low voltage cable
Sensor Length	between mounting holes: 3.4” (86.1mm)
Sensor Width	between mounting holes: 1.8” (46.5mm)
Sensor Height	1” (25.4mm)
Smoke Sensitivity	1.06 ± .26% per foot
Temperature Alarm	Fixed set point 54°C ± 2°C (129°F ± 4°F) and ≥ 10°C (18°F) per minute temperature rise
Audible Alarm	Yes
LED Indicator	Yes
Conformance	The sensor is NOT UL or EL approved. It is intended for supplementary protection.
Warranty	2 Years

*PLEASE NOTE*

The smoke and heat sensor is intended for supplementary protection and does not take the place of an approved smoke detector, as required by code. This product is NOT intended for use as a life saving device.