Netafim Single Drip Stake Assembly

Dripper Stake Assemblies

Netafim Single dripper stake assemblies will reduce set up time considerably. This 36 or 48 inch assembly will install right where you need it. Dripper assembly uses a 0.3 or 0.5 gph pressure compensating emitter with CNL check vale, 36 or 48 inches of Super Flex Tubing and an angled barbed stake. Minimum operating pressure is 10 psi.

Delivering superior uniformity with slow, low-flow drippers for even and uniform soil wetting without the run-off.

The Netafim Dripper Stake Assembly is ideal for soilless substrates and hydroponic applications because each plant pot or rock wool cube receives an equal and precise amount of water nutrients.

The slower and lower flow wet the soil media thoroughly without any run-off around the edges of the container. This allows longer runs on smaller polyethylene supply laterals maintaining excellent uniformity while holding down system costs. The PCNL dripper feature ensures that each plant receives the same amount of water at the same time. A built-in check valve assures that all the drippers will turn on – when the system is fully pressurized – and off at the same time. Dripper Stake Assembly with PCNL dripper offers high performance for a very low cost per plant position.

Why Dripper Stake Assemblies?

Higher Uniformity = Higher Crop Values

Most sprinkler systems lack uniform coverage and this creates wet and dry areas. Plant foliage interferes with water reaching the container. The result is a necessity to overwater many plants in order to provide adequate water to the dry areas and to overcome the interference of foliage. Netafim Dripper Stake Assemblies overcome these obstacles by delivering water directly to the plant. Each dripper adjusts itself automatically to the system pressure resulting in a watering uniformity of 94% – even on slopes. Since all water is delivered directly to the container, there is no run-off – no overspray into the aisles saving water, fertilizer, and energy.