The perfect sensor to help monitor your pH 24/7.
NOTE: Hub-Ready Sensors Require a Pulse Hub Base To Operate.
The PH-1 sensor is meant to be fully submerged in your tank/reservoir. You can use the included mounting bracket for mounting the sensor, or you can use the 3/4" NPT threading for inline installation. When mounting make sure the positioning allows the tip of the sensor to remain fully submerged and in a spot where it won't get knocked around.
Use and Maintenance
Your sensor(s) will need periodic cleaning and calibration. The maintenance cycle can vary depending on your environment. These probes do not last forever; They age through normal use and will eventually fail. To ensure you receive a long life from your sensor, please follow proper use/maintenance instructions. Replacement PH Probes are available. Please reach out to us at email@example.com.
PH-1 sensors are calibrated by inserting them into PH4, PH7, and then PH10 solutions. The sensor has to be inserted into each solution successively. To enter calibration mode, you want to enter your device settings, and then follow the onscreen instructions for calibration.
Be the first to review this product
Expert Advice Toll-Free
© 2011-2023 Hydrobuilder.com - 500 Orient Street Suite 150, Chico, CA 95928 USA
All trademarks and trade names are the property of their respective trademark holders.