AXEON R1 Series Reverse Osmosis System

AXEON R1–Series Reverse Osmosis Systems are designed for overall superior performance, high recovery rates, minimal energy consumption and offer great savings with low maintenance and low operation costs.

R1–Series Reverse Osmosis Systems feature a new, innovative design. These systems feature only the highest quality components, including a programmable computer controller with many builtin standard features, a stainless steel booster pump for high performance and corrosion resistance, ultra housings for enhanced performance and durability.

R1–Series Reverse Osmosis Systems have been engineered for capacities ranging from 1,800-21,600 gallons per day

BENEFITS

FEATURES

A Closer Look At The R1 Series

• 1.) Filter In - Measures feed pressure which needs a minimum > 45 psi. Lower pressure can create low pressure faults.
• 2.) Differential pressure is measured based on the Filter In and Filter Out and if it exceeds

• 3.) Filter Out - Pressure must be above > 40 psi. Low pressure switch will shut off unit when it goes below
• 4.) Pump Pressure - Displays pressure after the RO Pump and before
• 5.) If differential pressure on these two gauges shows above 15 psi per each membrane housing (ex. 3 membranes in series would add up to 45+ psi) then membrane likely is fouled. Clean or replace membranes.
• 6.) Concentrate Pressure - Displays pressure after the last membrane.
• 7.) S150 Controller - Monitors functions from TDS, temperature, rejection (with dual TDS Option) RO pump, pressures and solenoid valve. Voltage standard is 220 1 pH and optional 3 pH, voltage 380, 460, 575 VAC. This controller is UL/CL certified
• 8.) Permeate - Shows the amount of water being produced in GPM (Gallons Per Minute), also known as Product Water.
• 9.) Concentrate/Concentrate Valve - Measures flows of waste water using an integrated needle valve to adjust pressure and flows
• 10.) Concentrate Recycle/Concentrate Recycle Valve - Measures flows of recycled water from the waste water side for higher recover using an integrated needle valve to adjust flows. This is used in conjunction with concentrate water.
• 11.) Solenoid Valve - The ASCO brand solenoid is a composite valve that lets water in or stops based on RO demand. The size is 1" FNPT (female pipe thread). ALWAYS have the same size or larger pipe.
• 12.) Sediment Filter - This uses a 4.5" x 20" filter that traps particulates as low as 5 microns using a 5 mic filter

• 13.) RO Pump - This produces the required pressure for the RO system. The R1 has two sizes: 1.5 hp for the R1–1140 to R1– 4140 and 3 hp for the R1–5140 to R1–12140.
• 14.) Injection Port - This is for the injector used in a chemical injection system. This injects a chemical to help prevent fouling of the membrane. S200 is the chemical used to sequester hardness so it won't plug the membranes. Up to 300 GPG.

• 15.) Pump Throttle Valve -This controls the flow and pressure from the pump. NEVER fully close this or damage will occur from heat and dead heading.
• 16.) Fiberglass Pressure Valve - Stores membranes (HF5– 4040) that produce clean water.
• 16.) Injection Power - Power source only for the chemical injection pump. It is not to be used for anything else or overloading can occur.

SPECIFICATIONS

OPERATING LIMITS