This latest monitor/controller has built upon a pedigree of simplicity and innovative features. The EC Mini may be used as a mains-powered monitor or, by adding two peristaltic pumps, it becomes a fully functional dosing system, managing fluctuations in either your Electric Conductivity, Conductivity Factor, or Total Dissolved Solids. EC, CF, and TDS fluctuations in your reservoir are not only time-consuming to correct but can have negative effects on your crop performance.
Adding peristaltic pumps will allow you to keep your EC adjuster in larger containers on the floor, avoiding issues associated with gravity-fed valves.
The EC Mini Contoller display shows EC (CF/TDS), Dose Count Total (DCT) and Dose Count per Hour so you can fine tune your set up to your exact needs.
Checking dose count is useful if a leak should develop or the pump fail and should prevent continuous dosing alarms. The alarms can be enabled to operate on the controller when the EC or DC/h deviates outside the user set-point.
The EC Mini is affordable enough to be used as a mains powered monitor, continuously displaying the measured electrical conductivity. By adding solenoid valves or dosing pumps it becomes a low cost dosing system.
Typical EC Mini Installation Set Up
|Lead Time||This product ships in 48 hours|
Be the first to review this product
Expert Advice Toll-Free
© 2011-2023 Hydrobuilder.com - 500 Orient Street Suite 150, Chico, CA 95928 USA
All trademarks and trade names are the property of their respective trademark holders.