The Atlas 3 controls (500 PPM to 2000 PPM) and monitors (500 PPM to 5000 PPM) CO2 and offers CO2 enrichment or CO2 exhaust features.
Caution: Sulphur vaporization can damage your controller! To protect your controller, it is important to disconnect and cover the Atlas 3 by wrapping with a plastic bag OR remove the controller from the grow area while using sulphur vaporizers in your grow room.
Titan Controls Atlas 3: Day/Night CO2 Monitor/Controller Videos
Titan Controls Atlas 3: Day/Night CO2 Monitor/Controller Questions & Answers
I'm getting "Er.1" showing on my Atlas 3 LCD display. What does it mean?
This is 'Error Code 1' for the Atlas 3. This is a problem with the CO2 sensor in the controller. To fix it, just turn off the power, wait five seconds and then reactivate the controller.
I'm getting "Er.8" showing alternately with the sensor values on my Atlas 3 LCD display. What does it mean?
This is 'Error Code 8' for the Atlas 3. This is a memory corruption problem and all your preferred settings will be reset to the default factory settings. To fix it, re-enter your preferred settings.
Does my Titan Controller need to be calibrated?
No, your controller has been factory calibrated and is ready for service when you take it out of the box. Each unit will provide years of use and will maintain its settings without any further changes required.
Should I run my CO2 at night?
No, you should not. Plants photosynthesize CO2 only during the daylight hours. At night, the plants expire CO2 and have no use for CO2. Save yourself some money and only dose CO2 during daylight hours when it does the most good for the plants.
easy to use Review by greenfreak
(Posted on February 8, 2016)